Design of Steel Structures MCQs with answers Page - 25

Here, you will find a collection of MCQ questions on Design of Steel Structures. Go through these questions to enhance your preparation for upcoming examinations and interviews.

To check the correct answer, simply click the View Answer button provided for each question.

Have your own questions to contribute? Click the button below to share your MCQs with others!

+ Add Question

A

Admin • 833.24K Points
Coach

Q. Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is

  • (A) 180
  • (B) 200
  • (C) 250
  • (D) 350

A

Admin • 833.24K Points
Coach

Q. Normally, the angle of roof truss with asbestos sheets should not be less than

  • (A) 26½°
  • (B) 30°
  • (C) 35°
  • (D) 40°

A

Admin • 833.24K Points
Coach

Q. An imaginary line along which rivets are placed, is known as

  • (A) rivet line
  • (B) back line
  • (C) gauge line
  • (D) all the above

A

Admin • 833.24K Points
Coach

Q. The capacity of the smallest pressed steel tank is

  • (A) 1000 litre
  • (B) 1650 litre
  • (C) 1950 litre
  • (D) 2450 litre

A

Admin • 833.24K Points
Coach

Q. The permissible stress to which a structural member can be subjected to, is known as

  • (A) bearing stress
  • (B) working stress
  • (C) tensile stress
  • (D) compressive stress

A

Admin • 833.24K Points
Coach

Q. Tacking rivets in tension members, are provided at a pitch in line not exceeding

  • (A) 25 cm
  • (B) 50 cm
  • (C) 75 cm
  • (D) 100 cm

A

Admin • 833.24K Points
Coach

Q. In case of timber structures, the form factor for solid circular cross-section is taken as

  • (A) 1.18
  • (B) 1.414
  • (C) 1.67
  • (D) 1.81

A

Admin • 833.24K Points
Coach

Q. The distance between the outer faces of flanges of a plate girder, is known as

  • (A) overall depth
  • (B) clear depth
  • (C) effective depth
  • (D) none of these

A

Admin • 833.24K Points
Coach

Q. When the depth of a plate girder is at least times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if is

  • (A) 2
  • (B) 4
  • (C) 6
  • (D) 8

A

Admin • 833.24K Points
Coach

Q. Which of the following conditions is to be satisfied both in elastic and plastic analysis?

  • (A) equilibrium condition
  • (B) yield condition
  • (C) plastic moment condition
  • (D) mechanism condition

Add MCQ in this Category

If you want to share an MCQ question in this category, it's a great idea! It will be helpful for many other students using this website.

Share Your MCQ

Browse Categories

Click on category to learn MCQs of that category.