Design of Steel Structures MCQs with answers Page - 24

Here, you will find a collection of MCQ questions on Design of Steel Structures. Go through these questions to enhance your preparation for upcoming examinations and interviews.

To check the correct answer, simply click the View Answer button provided for each question.

Have your own questions to contribute? Click the button below to share your MCQs with others!

+ Add Question

A

Admin • 833.24K Points
Coach

Q. When a large value of radius of gyration is not required

  • (A) channels are placed back to back
  • (B) channel flanges are kept inward
  • (C) channel flanges are kept outward
  • (D) none of these

A

Admin • 833.24K Points
Coach

Q. The ratio of hydrostatic stress to the volumetric strain within the elastic range, is called

  • (A) modulus of elasticity
  • (B) shear modulus of elasticity
  • (C) bulk modulus of elasticity
  • (D) all the above

A

Admin • 833.24K Points
Coach

Q. Long column is one

  • (A) which is more than 3 m long
  • (B) whose lateral dimension is less than 25 cm
  • (C) which is free at its top
  • (D) which has a ratio of effective length and least lateral dimension more than 15

A

Admin • 833.24K Points
Coach

Q. When the length of a tension member is too long

  • (A) a wire rope is used
  • (B) a rod is used
  • (C) a bar is used
  • (D) a single angle is used

A

Admin • 833.24K Points
Coach

Q. The minimum thickness of plates in a steel stack should be

  • (A) 4 mm
  • (B) 5 mm
  • (C) 6 mm
  • (D) 8 mm

A

Admin • 833.24K Points
Coach

Q. To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be

  • (A) < l/3
  • (B) < l/6
  • (C) > l/3
  • (D) > l/6

A

Admin • 833.24K Points
Coach

Q. Compression force in two end posts, the pin of a rocker bearing in a bridge is designed for

  • (A) bearing and shear
  • (B) bending and shear
  • (C) bearing and bending
  • (D) bearing, shear and bending

A

Admin • 833.24K Points
Coach

Q. The ratio of plastic section modulus to elastic section modulus

  • (A) is equal to 1
  • (B) is always less than 1
  • (C) is always greater than 1
  • (D) can be less than 1

A

Admin • 833.24K Points
Coach

Q. Bulb angles are used in

  • (A) column building
  • (B) bridge building
  • (C) ship building
  • (D) water tank building

A

Admin • 833.24K Points
Coach

Q. The diameter of a bolt hole is taken as the nominal diameter of the bolt plus

  • (A) 1.0 mm
  • (B) 1.2 mm
  • (C) 1.4 mm
  • (D) 1.6 mm

Add MCQ in this Category

If you want to share an MCQ question in this category, it's a great idea! It will be helpful for many other students using this website.

Share Your MCQ

Browse Categories

Click on category to learn MCQs of that category.