Automobile Engineering MCQs with answers Page - 14

Here, you will find a collection of MCQ questions on Automobile Engineering. Go through these questions to enhance your preparation for upcoming examinations and interviews.

To check the correct answer, simply click the View Answer button provided for each question.

Have your own questions to contribute? Click the button below to share your MCQs with others!

+ Add Question

A

Admin • 828.03K Points
Coach

Q. The diagram which shows the correct crank positions corresponding to the opening and closing of the valves, is known as

  • (A) indicator diagram
  • (B) value timing diagram
  • (C) axial force diagram
  • (D) None of the above

A

Admin • 828.03K Points
Coach

Q. Which is the Diesel engined vehicle

  • (A) Ambassador Mark II
  • (B) Premier padmini
  • (C) Standard Gazel
  • (D) None of the above

A

Admin • 828.03K Points
Coach

Q. Executive clutch clearance caused by improper adjustment or wear of sliding sleeve, generally results in

  • (A) Clutch slip
  • (B) Clutch failure to disengage
  • (C) Clutch plate over heating
  • (D) Uneven clutch engagement

A

Admin • 828.03K Points
Coach

Q. Balls for a ball bearing are made of

  • (A) Stainless steel
  • (B) Carbon chrome steel
  • (C) High speed steel
  • (D) Mild steel

A

Admin • 828.03K Points
Coach

Q. In spark plug the gap between the electrodes is

  • (A) 10 mm
  • (B) around 5 mm
  • (C) around 1 mm
  • (D) less than 1 mm

A

Admin • 828.03K Points
Coach

Q. The device used to measure the clearance between the valve and tappet of an internal combustion engine is

  • (A) Slip gauge
  • (B) Thickness gauge
  • (C) Feeler gauge
  • (D) Snap gauge

A

Admin • 828.03K Points
Coach

Q. The condenser in ignition circuit of an S.I. engine

  • (A) increases the battery voltage
  • (B) decreases the current from battery
  • (C) avoids arcing at contact breaker
  • (D) none of the above

A

Admin • 828.03K Points
Coach

Q. In an automobile the probable cause for dragging brakes could be

  • (A) Lack of clearance
  • (B) Drums out of round
  • (C) Loose wheel bearings
  • (D) Any of the above

A

Admin • 828.03K Points
Coach

Q. When fully charged, the terminal voltage per cell for a battery is

  • (A) 1.5 volts
  • (B) 2.7 volts
  • (C) 1.7 volts
  • (D) 6 volts

A

Admin • 828.03K Points
Coach

Q. For the best utilization of fuel, in the engine cylinder, the air supply should be

  • (A) About 10% surplus
  • (B) 15 to 20 percent deficient
  • (C) About 25% surplus
  • (D) 5 to 10 percent deficient

Add MCQ in this Category

If you want to share an MCQ question in this category, it's a great idea! It will be helpful for many other students using this website.

Share Your MCQ