Automobile Engineering MCQ Questions and answers

A

Admin • 831.35K Points
Coach

Q. Starting motor current may be around

(A) 0.1 A
(B) 25 A
(C) 1.0 A
(D) 0.5 A

A

Admin • 831.35K Points
Coach

Q. The purpose of the dynamo in an automobile is to

(A) Act as a reservoir of electrical energy
(B) Convert mechanical energy into electrical energy
(C) Supply electric power
(D) Continually recharge the battery

A

Admin • 831.35K Points
Coach

Q. In a vehicle if there is no king pin offset

(A) Starting steering effort will be high
(B) Starting steering effort will be zero
(C) bracking effort will be high
(D) Wobbling of wheels will increase

A

Admin • 831.35K Points
Coach

Q. In a four stroke engine, for the combustion of one litre of fuel, the
volume of air required would be approximately

(A) 5 - 7 cu-m
(B) 15 - 16 cu-m
(C) 9 - 10 cu-m
(D) 1 cu-m

A

Admin • 831.35K Points
Coach

Q. The number of revolutions per km for a free rolling tyre are less than that calculated from its static radius. This difference in number of revolutions is due to

(A) hysteresis of the tyre materials which make the dynamic loaded radius somewhat larger than the static radius
(B) forces in the contact area that cause slight forward of the tread
(C) either of A and B
(D) None of the above

A

Admin • 831.35K Points
Coach

Q. The reaction time of an average driver from recognizing an obstacle is taken as

(A) 0.5 to 1.7 seconds
(B) 4.5 to 7.0 seconds
(C) 3.5 to 4.5 seconds
(D) 2 to 3.5 seconds

A

Admin • 831.35K Points
Coach

Q. The fuel is injected into the cylinder in Diesel engine when the piston is

(A) Pump the fuel to the injector
(B) Exactly at T.D.C. after compression stroke
(C) Approaching T.D.C. during compression stroke
(D) Just after T.D.C. during exhaust compression stroke

A

Admin • 831.35K Points
Coach

Q. Dilution of lubricating oil is caused by

(A) Solid contaminants like dust, etc.
(B) Solid combustion residues
(C) Worn off particles
(D) Fuels

A

Admin • 831.35K Points
Coach

Q. The function of oil scraper rings is to

(A) Lubricate cylinder walls
(B) Retain compression
(C) Reduce piston wear
(D) Maintain vacuum

A

Admin • 831.35K Points
Coach

Q. Speedometer drive is usually taken from

(A) Gear box
(B) Fan belt
(C) Front wheel
(D) Dynamo

Automobile Engineering MCQs with answers Page - 1

Q. Starting motor current may be around

Q. The purpose of the dynamo in an automobile is to

Q. In a vehicle if there is no king pin offset

Q. In a four stroke engine, for the combustion of one litre of fuel, the
volume of air required would be approximately

Q. The number of revolutions per km for a free rolling tyre are less than that calculated from its static radius. This difference in number of revolutions is due to

Q. The reaction time of an average driver from recognizing an obstacle is taken as

Q. The fuel is injected into the cylinder in Diesel engine when the piston is

Q. Dilution of lubricating oil is caused by

Q. The function of oil scraper rings is to

Q. Speedometer drive is usually taken from

Add MCQ in this Category

Browse Categories

Automobile Engineering MCQs with answers Page - 1

Q. Starting motor current may be around

Q. The purpose of the dynamo in an automobile is to

Q. In a vehicle if there is no king pin offset

Q. In a four stroke engine, for the combustion of one litre of fuel, the volume of air required would be approximately

Q. The number of revolutions per km for a free rolling tyre are less than that calculated from its static radius. This difference in number of revolutions is due to

Q. The reaction time of an average driver from recognizing an obstacle is taken as

Q. The fuel is injected into the cylinder in Diesel engine when the piston is

Q. Dilution of lubricating oil is caused by

Q. The function of oil scraper rings is to

Q. Speedometer drive is usually taken from

Add MCQ in this Category

Browse Categories

Q. In a four stroke engine, for the combustion of one litre of fuel, the
volume of air required would be approximately