Networking MCQs with answers Page - 74

Here, you will find a collection of MCQ questions on Networking. Go through these questions to enhance your preparation for upcoming examinations and interviews.

To check the correct answer, simply click the View Answer button provided for each question.

Have your own questions to contribute? Click the button below to share your MCQs with others!

+ Add Question

A

Admin • 833.24K Points
Coach

Q. Which command verifies the routing table entries on a Cisco router?

  • (A) show ip route
  • (B) show interfaces
  • (C) show startup-config
  • (D) show ip protocols

A

Admin • 833.24K Points
Coach

Q. What is the main advantage of dynamic routing over static routing?

  • (A) It automatically adapts to network changes
  • (B) It consumes less bandwidth
  • (C) It provides higher security
  • (D) It requires no CPU processing

A

Admin • 833.24K Points
Coach

Q. Which of the following is a link-state routing protocol?

  • (A) RIP
  • (B) EIGRP
  • (C) OSPF
  • (D) BGP

A

Admin • 833.24K Points
Coach

Q. Which type of attack targets routers by flooding them with route updates?

  • (A) Route flapping
  • (B) Routing table poisoning
  • (C) Denial of Service (DoS)
  • (D) Phishing

A

Admin • 833.24K Points
Coach

Q. What is the purpose of QoS (Quality of Service) in routing?

  • (A) To manage bandwidth and prioritize network traffic
  • (B) To encrypt routing tables
  • (C) To detect viruses
  • (D) To improve wireless signal strength

A

Admin • 833.24K Points
Coach

Q. Which router component is responsible for storing the startup configuration?

  • (A) RAM
  • (B) NVRAM
  • (C) Flash memory
  • (D) ROM

A

Admin • 833.24K Points
Coach

Q. What does the term 'asymmetric routing' refer to?

  • (A) When packets take different paths in opposite directions
  • (B) When packets are dropped due to congestion
  • (C) When routers have equal-cost paths
  • (D) When NAT is applied incorrectly

A

Admin • 833.24K Points
Coach

Q. Which IPv6 address type is used for one-to-one communication?

  • (A) Multicast
  • (B) Anycast
  • (C) Unicast
  • (D) Broadcast

A

Admin • 833.24K Points
Coach

Q. What is the purpose of the 'show version' command on a router?

  • (A) To view software version and hardware details
  • (B) To display active routing protocols
  • (C) To list IP addresses
  • (D) To reset routing configuration

A

Admin • 833.24K Points
Coach

Q. Which of the following routing protocols supports both IPv4 and IPv6?

  • (A) RIP v1
  • (B) OSPFv3
  • (C) BGP v3
  • (D) ARP

Add MCQ in this Category

If you want to share an MCQ question in this category, it's a great idea! It will be helpful for many other students using this website.

Share Your MCQ

Browse Categories

Click on category to learn MCQs of that category.